Column Left Debug: 0
Evercoat® 400 Glazing Putty
Product Description
The original polyester glazing putty can be applied directly to bare metal, body filler, fiberglass, and fully cured sanded top coats. It easily fills grind marks, pinholes, low spots, and other minor imperfections. There is no shrinkage. It is easy to dry and reduces the risk of staining.
Polyester Glazing Putty is an ultra-smooth paste putty that easily fills pinholes, low spots, and other minor imperfections. It also can be used to fill minor body damage up to 1/8” deep. Polyester Formulated for maximum adhesion to galvanized steel, bare steel, aluminum, SMC, E-coat, and cured OEM finishes. Evercoat® 400 Glazing Putty can also be used to fill minor body damage up to 1/8” (3 mm) in depth.
Blue cream hardener is included.
Approved Substrates:
- Sanded Body Filler
- SMC
- Fiberglass
- E-Coat
- Steel
- Aluminum
- Galvanized Steel
- Sanded OEM Paint
NOTE: For flexible plastics, use POLY-FLEX™ Flexible Glazing Putty.
Preparation
Clean and degrease the entire panel to be repaired with soap and water, followed by a mild cleaning solvent.
Thoroughly dry the surface before repairing.
Use 80-180 grit to remove or scuff the paint and featheredge.
Mixing:
Place the desired amount of material on a clean, non-fibrous surface. Knead the cream hardener before use. Measure hardener 2% by weight (add a ribbon of cream hardener from the edge to edge across the center of a 4” (10 cm) diameter puddle. Puddles larger than 4” in diameter will require additional hardener. Mix thoroughly until uniform color is achieved. Approximate setting time is 2.5 - 5 minutes @ 72°F (22°C)
Application
Spread a thin layer of mixed material over the surface using firm pressure. Apply additional layers to build material slightly higher than the surface to allow for sanding to the desired contour.
NOTE: Do not apply over new or uncured coatings. Avoid thick heavy
applications.
Finish:
Sand to contour with 180-grit sandpaper. If desired, final sand with 180 grit followed by 220-320 grit.
Topcoat:
Apply 2K polyester, 2K urethane, 2K epoxy, or 1K primer to the manufacturer’s recommendations
Appearance: White Paste
VOC: Refer to Section 9 of the Safety Data Sheet
Relative Density: Refer to Section 9 of the Safety Data Sheet
Sand Time: 12-20 min.
Max Recommended Thickness: 1/8 inch (3mm)
(sanded)
Related Products
