Column Left Debug: 0
*This Item Ships From South Florida Click to See Estimated Transit Times
PREPARATION: Surface preparation is same as for the finish.
APPLICATION:
WOOD filled with Interstain: Apply 1-2 coats. This will seal the wood and filler and then the paint or varnish of choice can be applied as directed.
PLYWOOD: It is important to saturate the porous white summer grain of the wood until it takes on a glossy appearance. At least 2 coats will be required to reach this condition. Once gloss is obtained, the wood should be sanded with 120 grade (grit) paper before applying finish coats of paint or varnish.
TIPS:
Thinner: Brush -Brushing Liquid 333. Spray -Special Thinner 216.
Ventilation and Humidity Control: It is best to paint on warm, dry mornings. Cold weather retards the drying and humidity can spoil the gloss.
Airless Spray: Pressure: 170-204 bar/2500-3000 psi. Tip Size: 0.33-0.41 mm/13-16 thou.
Conventional Spray: Pressure Pot: Pressure: 3.44-4.47 bar/50-65 psi (gun pressure); 8-10 psi (pot pressure). Tip Size:0.89-1.4 mm/35-50 thou. Siphon Cup: Pressure: 3.44-4.47 bar/50-65 psi -gun pressure. Tip Size: 1.5-1.8 mm/60-70 thou.
Roller: If rolling, use a thin nap roller and "tip-off" with a clean natural bristle brush.
Other: Spray pressures listed are recommendations only. The applicator may use any settings which yield the best results for the individual spraying technique and current weather conditions.
Compatibility: Apply to clean, dry, properly prepared surfaces only. Inter-Prime Wood Sealer Clear is not a finish paint and must be overcoated with varnish or paint. Do not apply two part varnishes over Inter-Prime Wood Sealer Clear. Do not use with two part epoxies. Plywood must be sealed prior to painting. Failure to stabilize the white summer grain by saturating withthe sealer will cause premature paint failure. If the soft, porous, white grain is not sealed, subsequent coats of paint will crack and check causing paint delamination.
**IMPORTANT: Never leave bare wood exposed for long periods of time as it will absorb moisture. Avoid painting in direct sunlight. Product temperature should be minimum 10°C/50°F and maximum 29°C/85°F. Ambient temperature should be minimum 10°C/50°F and maximum 35°C/95°F. Substrate temperature should be minimum 10°C/50°F and maximum 29°C/85°F.
Color: Y1026-Clear
Finish: Gloss
Specific Gravity: 0.876
Volume Solids: 36%
Typical Shelf Life: 2yrs
VOC (As Supplied): 540 g/lt
Dry and Overcoat Times: See Technical Data Sheet
Coverage: 200-400 (ft²/Gal) depending on porosity
Number of Coats: 2-3 depending on porosity
Storage and Handling: Exposure to air and extremes of temperature should be avoided. For the full shelf life of Inter-Prime Wood Sealer Clear tobe realised ensure that between use the container is firmly closed and the temperature is between 5°C/41°F and 35°C/95°F. Keep out of direct sunlight.
Click Here for Product Technical Data Sheet
